Urban modelisation

[Aelin]

Like you said J
Finally i abandonned to cut the middle wall. I wish not to do an UV map this time in Wings, even if with him i understand a little how to do.
So i push in X the size of walls around, putting them in X=150%.

Otherwise, i can't unify the stairs for street; it's a simple geometry, but they refuse to obey at the "Weld" command The result was a crash (W3D, and for a moment the session of computer) last night when i tried to change the size of last stair to do the sidewalk

[Jherrith]

[thelufias]

If it were me doing this I'd be pulling my hair out.....Oh wait....I'm bald.... :yeow:

[Aelin]

I have no idea why, but in the video 11 he is able to use "plane cut"; for me, it's impossible to have 2 separated objects at the end.
I'm forced to separate in 3 indeed with "plane cut". But after, i have 2 parts of wall with holes on one side
I must select manually each edge near to hole, then connect with the similar edge in front of in width. Then "hardness" tool.
*********
Edit: i try the manual thing. Because it's not a success

[Aelin]

I'm in video 7; all i know it's i made wrong something in the video 6, with a bevel because when we must play with "connect" i have a different number of faces and a different geometry.

[Aelin]

[thelufias]

My ears are still ringing 

[Aelin]

Indeed! Mainly when his W3d version is a bit different of this of now  :yeow:
The beginning of the third video shows the final result. Imagine the shout I launched earlier

[thelufias]

That'll keep you busy Aelin........wooohooo

[Aelin]