Make a corinthian column?

[Aelin]

Problem now is to have squares it's hard to have for the moment.
I know on another 2D toward 3D object I tried I was able finally to obtain a lot of squares - it's not a pretty object, just my real first test. Here, it will be very hard - I obtain more "stars" lines. I know to export after it's better to have squares, but probably I won't have them.

I haven't really ended to 'sculpt' that face, so I must end that.
Like it's not symmetric, I don't think to join faces will be do like that. Probably I'll use a little square, then "intrude" the back face to have a more little part. Then bridge all to the square.

[mtdana]

Great progress - looks good!!! :lite2:

[Aelin]

Fortunately, not yet! 

I ended the shape around.
Then came the moment to draw everything inside. How to do? I cut vertically in 2 parts in the middle, like you saw the last time.
Then I had to create a new point on the 'bottom' line, and rely it to another in the 'top' shapes. Cut the new line with a lot of points, to do like for the shape around, like it's shown in the video for the gun.
But in the middle it's different. Because after a time you need to remove a part of the lines, to connect some points with others.
Brief, ok maybe I do more complicated than in Blender, but I continue to learn a lot with Wings.

And now, I'm just after the extrusion.
Colors are just to see where I go with each parts.

[attachment deleted by admin]

[mtdana]

Thoerically I can do the rest of column without problem yes. Except if amnesia comes suddenly

Or unless wings get haunted

[Aelin]

Thoerically I can do the rest of column without problem yes. Except if amnesia comes suddenly

Blender seems always a world far away for the moment

If you try to see pics when you are responding, in messages below, yes nobody can see them. You must open another tab to answer, and to continue to see the topics with pics, videos, other possible attached files...
It took time before I noticed that, then how to do.

[Aelin]

I tried by separate stuff, but result was... well impossible to name it, but it wasn't something like a banana for sure

My intention is already to do a face, then to see what happens. I don't want to do a 100% identical, or details with be killed!
I will use mainly cut for edges, then extrusion. Probably bevel tool for few parts. And at the end smooth on several parts.
It's all that I think for tonight. But brain starts to be ko 

[Aelin]

Even without Tweak it's possible to move several points. Either when you cut a line in several parts, you keep points in red and you make the job. Or selecting those which interest you.
Maybe less intuitive, but concentration always  lol

I'm in the phase of create lines inside.

But I must admit I have some edges which are there but not always possible to see Sometimes when I move a little a point it's ok to show again an edge, but the neighbor edge can do the same trick suddenly

[attachment deleted by admin]

[mtdana]

A banana, at least you could identify it! Normally what I make can't be lol


Aelin, Tweak will let you move a group of point at the same time and it is similar to sculpt mode which you have used, so I don't think it would take long for you to lean it.

[Aelin]

And no minions to eat it? lol

I'm pretty sure this time I'll be able to do the shape around. It's inside that is a big "?".

I'm not in Tweak mode no, but I saw she has a different way to move points compared to me indeed.
I prefer for the moment the move X, move Y like I do, even if it takes more time. I'm forced to keep my concentration.

[mtdana]

Also she is in tweak mode, not sure the tut was clear about that. Good luck  :lite2: